Part 2

Assembling the pre-cut boards. These include three 2 x 6's 22" long, One 1 x 6 - 22" long, two 2 x 6's 15-1/2" long, two 2 x 4's 15-1/2 long, and two 2 x 4's 7-1/2" long. (These pieces build 1 table support. You'll need the same number to build a second.)



Measure 4-1/2" in, draw line width of 1 x 6. Then place an X 1-1/2" from each edge for screw placement.



Pre-drill screw holes at the X. Drill bit size must be smaller than screw size or screw will simply slide through.



Screw size must be long enough to attach wood pieces, but not go all the way through. This screw is 2" long. Notice that the 1x6 is on top and the 2x6 is on the bottom. This is for stability.




Four 2" screws are set in. When all 4 are set, re-align wood and finish screwing in.